Research tools
Peptide Dilution Calculator
Calculate how much stock solution and diluent are needed for a target concentration and final volume. Switch to serial mode to plan a repeated dilution factor.
Calculate how much stock solution and diluent are needed for a target concentration and final volume. Switch to serial mode to plan a repeated dilution factor.
Peptide Dilution Calculator
Find stock and diluent volumes for a single solution or a serial dilution.
Calculated estimates from your inputs
Enter the required values to calculate.
Worked example
5 mg/mL stock → 1 mg/mL in a final 1 mL.
Stock volume = 1 × 1 ÷ 5 = 0.2 mL. Diluent volume = 1 − 0.2 = 0.8 mL.
Arithmetic illustration only; not a protocol or amount to use.How to use the Peptide Dilution Calculator
- Choose single dilution for one working solution, or serial dilution for repeated steps.
- Enter your starting stock concentration and choose its unit. For a single dilution, enter the target concentration and final total volume.
- For serial dilution, enter the dilution factor, number of steps and volume prepared in each tube. A factor of 10 means one part source in ten total parts.
- Review the stock transfer and diluent volumes. In the serial table, check the volume remaining after the next transfer as well as the prepared volume.
Use Try an example to see how the fields and answer fit together. Replace the example values with your own research inputs before saving a record.
Understand dilution units
Stock and target concentrations must describe the same kind of concentration. For example, 5 mg/mL equals 5000 µg/mL, and 1 mM equals 1000 µM. The calculator can compare compatible units. A mass concentration such as mg/mL cannot be compared directly with a molar concentration such as µM without knowing the molecular weight. Use the Peptide Molarity Calculator first when you need that conversion.
Final prepared volume includes both the stock transferred and the diluent. It is not the diluent volume alone. In a serial dilution, a tube normally has less liquid after some is transferred to the next tube.
How a single dilution works
Dilution lowers concentration by increasing total volume while conserving the amount of compound transferred. The relationship is C1 times V1 equals C2 times V2. C1 is stock concentration, V1 is stock volume transferred, C2 is target concentration and V2 is final working volume. The calculator first finds V1, then subtracts it from V2 to find the diluent volume.
Worked example
To prepare a final 1 mL at 1 mg/mL from a 5 mg/mL stock, the arithmetic gives 0.2 mL stock plus 0.8 mL diluent. This is a five-fold dilution. The example demonstrates volume calculations and does not identify an appropriate solvent or experimental concentration.
Serial dilutions
A serial dilution repeats the same dilution factor using the previous tube as the source for the next. The results distinguish the volume prepared in a tube from the volume remaining after a transfer into the next tube. Check both when planning available sample volume.
Check compatibility
Stock and target concentrations must use compatible units. A mass concentration and a molar concentration cannot be compared without a molecular weight. Use the molarity calculator first if you need to change between those concentration families.
Common questions
Can dilution make my stock more concentrated?
No. A target higher than the starting concentration cannot be reached by adding diluent.
What does a five-fold dilution mean?
One part stock makes five total parts of solution, so the remaining four parts are diluent.
Is the output a preparation protocol?
No. It calculates quantities from your inputs and does not determine solvent compatibility, mixing technique or experimental suitability.
Laboratory arithmetic only. These tools do not recommend doses, administration or use in people or animals. Verify inputs, material identity and calculations independently.
Content and arithmetic reviewed 4 November 2026.

